14
3.3 Battery charging
Charging steps:
– Drive the stacker to appointed charging place, park the stacker and render if safe.
– Open the cover(2) of holder and pull out the charging plug (1), then insert it into a
suitable power socket.
– Charge the battery until the charging indicator (3) continues to illuminate green.
– Remove the charging plug (1) from the power socket and insert it back into the holder
and close the cover(2). After charging, the stacker can now be operated.
– When the battery level is below 40%, charging is necessary.
– When charging, the walking function of the stacker is prohibited.
– Before the battery is fully charged, try not to interrupt the charging process.
The flashing LED indicates the charge status or a fault (for flashing codes see “LED
Display” table).
If the mains connector (1) is connected to the mains, all the stacker’s electrical functions
will be interrupted (electrical start block). The stacker cannot be operated.
– Remove the connector (1) from the socket and store it in the the cover(2) of holder
Charging continues automatically after a mains failure.
Charging can be interrupted by removing the mains connector and continued as
partial charging.
The main connector and cable must not be damage.
Before starting the stacker, the battery panel must be firmly closed.
Charging times
The duration of charge depends on the battery capacity.
To Next Page
Loading...
