HANGCHA CDD15-WS - A Correct Use and Application; Use According to Regulations

1
A Correct use and application
The “Guidelines for the Correct Use and Application of Industrial stackers” are
supplied with the stacker. The guidelines are an integral part of the operating
instructions and must be observed. National regulations apply in full.
The stacker described in the present operator manual is an industrial stacker
designed for lifting and transporting load units. It must be used, operatedandserviced
in accordance with the present instructions.
Any other type of use is beyond the scope of application and can result in damage to
personnel, the stacker or property. In particular, avoid overloading the stacker with
loads which are too heavy or placed on one side. The data plate attached to the
stacker or the load diagram are binding for the maximum load capacity. The industrial
stacker must not be used in fire or explosion endangered areas, or areas threatened
by corrosion or excessive dust.
Proprietor responsibilities:
For the purposes of the present operator manual the
“proprietor” is defined as any natural or legal person who either uses the industrial
stacker himself, or on whose behalf it is used. In special cases (e.g. leasing or renting)
the proprietor is considered the person who, in accordance with existing contractual
agreements between the owner and user of the industrial stacker, is chargedwith
operational duties.
The proprietor must ensure that the stacker is used only for the purpose it is intended
for and that danger to life and limb of the user and third parties are excluded.
Furthermore, accident prevention regulations, safety regulations and operating,
servicing and repair guidelines must be followed. The proprietor must ensure that all
stacker users have read and understood this operator manual.
Failure to comply with the operator manual shall invalidate the warranty. The same
applies if improper work is carried out on the stacker by the customer or third parties
without the permission of the manufacturer’s customer service department.
Attaching accessories
: The mounting or installation of additional equipment which
affects or supplements the performance of the industrial stacker requires the written
permission of the manufacturer. In some cases, local authority approval shall be
required.
Approval of the local authorities however does not constitute the manufacturer’s
approval.