2-4
SETUP
10 Waste Bottle Assembly ............................................. 1 pcs.
• Bottle Cap
• Desiccant
• Desiccant Cartridge
• Fittings, O-rings
• Tubes (Silicon and Teflon Tubing)
11 Calibration Key ........................................................ 1 pcs.
12 Power Cable ............................................................ 1 pcs.
13 USB Cable ............................................................... 1 pcs.
14 Instruction Manual Binder ......................................... 1 pcs.
15 USB Storage Device ................................................. 1 pcs.
16 HI 900 PC Application (Install Kit on USB Stick) ......... 1 pcs.
17 Quality Certificate .................................................... 1 pcs.
18 ISO 8655 Burette Compliance Report ........................ 1 pcs.
19 Karl Fischer Dual Platinum Pin Electrode .................... 1 pcs.
See Appendix 3 section A 3 Titrator components for pictures.
If any of the items are missing or damaged, please contact your sales representative.
Note: Save all packing materials until you are sure that the instrument functions correctly.
Any damaged or defective items must be returned in their original packing materials
together with the supplied accessories.
2.2 Safety Measures
The following safety measures must be followed:
1. Always ensure that the power-supply cable is connected to a grounded main power plug.
2. Never connect or disconnect the pump assembly with the titrator turned on.
3. Verify that the burette and the attached tubing are assembled correctly (see
Section 8.1
Burette Maintenance
for more details).
4. Always check that the titrant, solvent, waste bottles and the titration beaker are properly
assembled.
5. Always wipe up spills and splashes immediately.
To Next Page
Loading...
