Hanna Instruments HI 903 - Standard Name; Standard Type; Concentration Unit; Water Content

5-16
METHODS
5.5.11.1 Standard Name
This option allows the user to edit the name of the standard.
5.5.11.2 Standard Type
The user can select the type of the standard: Mass or Volume.
5.5.11.3 Concentration Unit
The concentration unit can be selected: %[W/W], ppm, mg/g, mg/mL.
5.5.11.4 Water Content
The concentration of the standard can be entered (content of water in the selected unit).
5.5.12 Standard Size
Enter the amount of standard used during titrant standardization.
Before the titrant standardization is started, the user is asked again to enter the standard
size. The standard size (mass and volume) can be acquired automatically from a compatible
analytical balance (when the balance feature is enabled - see Section
4.11, Setup Balance
Interface
).