Appendix
USER’S MANUAL 63
High Frequency: Set the output wave High Frequency.
Depth: Set the output wave Depth.
Max Frequency: Set the output wave Max Frequency.
FM: Change the output wave "AM" into "FM".
4.Generate the Ramp waveform
To output a Ramp Wave, please do the following steps:
1. Press the check box "Signal On" to open the wave output function.
2. Select the Wave Type "Ramp".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Duty: The duty of the output wave.
5.Generate the Trapezia waveform
To output a Trapezia wave, please do the following steps:
1. Press the check box "Signal On" to open the wave output function.
2. Select the Wave Type "Trapezia".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set output wave vertical level offset.
Rise Duty: Set the output wave rise duty.
High Duty: Set the output wave high duty.
Fall Duty: Set the output wave fall duty.
6.Generate the Gaussian waveform
To output a Gaussian Wave, please do the following steps:
1. Press the check box "Signal On" to open the wave output function.
To Next Page
Loading...
