Appendix
USER’S MANUAL 62
6.1 Generate Waveform
1.Generate the Sine waveform
To output a Sine Wave, please do the following steps:
1.Press the check box "Signal On" to open the wave output function.
2.Select the Signal Type "Sine ".
3.Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
2.Generate the Square waveform
To output a Square Wave, please do the following Step:
1. Press the check box "Signal On" to open the wave output function.
2. Select the Signal Type "Square".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Duty: Set the duty of the output wave.
3.Generate the AM/FM waveform
To output an AM/FM Wave, please do the following Steps:
1. Press the check box "Signal On" to open the wave output function.
2. Select the Wave Type "AM/FM".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
To Next Page
Loading...
