Appendix
USER’S MANUAL 65
Y Offset: Set the output wave vertical level offset.
Tao: Set the output wave Tao parameter.
Rise: Set the output wave slope.
Waveform output Setting
Output type:
Single: The waveform output only once. The user selects "Single", and clicks "Burst". Each time
you press, there will be output at a time.
Continue: Continue to output waveform.
Waveform generator is set to internal and external trigger. The oscilloscope trigger mode is set to
internal, that can measure waveform as follows:
To Next Page
Loading...
