Measure
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual
51
The X cursor is a vertical dashed line for horizontal adjustment that can be used to
measure time (s) and frequency (Hz).
X1 is the cursor AX, X2 is the cursor BX.
AX: the X value at the cursor X1.
BX: the X value at the cursor X2.
BX-AX: horizontal spacing between cursor X1 and cursor X2.
|1/dX|: the reciprocal of the horizontal spacing between cursor X1 and X2 cursor.
Vertical cursor movement
Use the touch screen function to adjust the cursor position by dragging gestures. For
details, see Dragging section.
10.3.2 Horizontal Cursor
The horizontal cursor displays a horizontal line on the screen that measure the horizontal
parameters of the waveform.
The operation steps are as follows:
⚫ Click the Horiz Cursor.
⚫ The horizontal line appears on the screen.
⚫ Drag the horizontal line to where you want to measure it.
⚫ The measurement results are displayed in the upper left corner of the screen.
Horizontal cursor display window:
Figure 10.3 Horizontal cursor
The Y cursor is a horizontal dashed line for vertical adjustment that can be used to
measure the amplitude (in the same unit as the source channel amplitude).
Y1 is the cursor AY, Y2 is the cursor BY.
AY: Y value at cursor Y1.
BY: Y value at cursor Y2.
BY-AY: Vertical spacing between cursors Y1 and Y2.
To Next Page
Loading...
