Hantek Tablet1000 Series - Remote Control; Install the IO Driver

Remote control
EN
Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual
79
21 Remote control
This chapter mainly includes the application of upper computer, in order to understand
the remote control function of Tablet1000 oscilloscope.
Install the IO driver:
Click on the following website to download the latest IO software:
- 11143.0.00 & id = 2175637
Double-click the application to start the installation. The installation process may take
several minutes.
After the installation, you can view the I/O software running in the lower right corner of
the screen.
Connect the Type-A end of the USB cable to the computer, and connect the Type-B end
to the USB interface at the back of the oscilloscope. A new device will display in
Computer Device Manager.
Double-click the IO software, and you can view the connected device information
displayed under My Instrument-USB.
Click "Interactive IO" and send an instruction, then the computer is in communication
with the oscilloscope.