Hantek Tablet1000 Series - Shortcuts; Auto Setting

Shortcuts
EN
Tablet1000 User manual Copyright © Qingdao Hantek Electronics Co., LTD
62
15 Shortcuts
Auto setting: Auto setup of oscilloscope controls to generate useful display of input
signals. See the following table for relevant information.
Click Auto at the bottom of the screen, and the oscilloscope will perform Auto setting
automatically.
Default setting: Automatically call out the default settings. Click Utility > Default.
15.1 Auto setting
Auto setting is one of the advantages of digital oscilloscopes. When you click Auto
setting, the oscilloscope will recognize the waveform type (sine or square) and adjust the
control mode to accurately display the waveform of the input signal.
Function
Settings
Acquisition mode
Sampling or peak detection
Cursor
OFF
Display mode
YT
Display type
FFT spectrum is set to vector. Otherwise, no change.
Horizontal position
Has been adjusted
SEC/DIV
Has been adjusted
Trigger coupling
Set to DC, noise suppression, or high frequency suppression
Trigger hold-off
20ns
Trigger level
50%
Trigger mode
Automatic
Trigger source
Has been adjusted. Automatic setting cannot be used for
external trigger signals.
Trigger slope
Has been adjusted
Trigger type
Edge
Video
synchronizatio
n trigger
Has been adjusted
Video trigger
standard
Has been adjusted
Vertical bandwidth
All
Vertical coupling
DC (if GND was previously selected). For video signals, set it to
AC. Otherwise, no change.