31
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Message Description
Constant-value operation is running.
-
Program operation is running.
-
Auto- tuning [Ch.1].
-
Auto-tuning [Ch.2].
-
It is in Hold operation.
-
It is in Wait operation.
-
Loading parameters.
-
Control communication error
Communication is unavailable with the control. Check the
connection and address.
[Ch.1] input communication error
Ch.1 temperature value of control is not communicated.
[Ch.2] input communication error
Ch.2 temperature value of control is not communicated.
IO[0] module communication error
Communication is unavailable with I/O module No.0.
IO[1] module communication error
Communication is unavailable with I/O module No.1.
IO[2] module communication error
Communication is unavailable with I/O module No.2.
IO[3] module communication error
Communication is unavailable with I/O module No.3.
IO[4] module communication error
Communication is unavailable with I/O module No.4.
IO[5] module communication error
Communication is unavailable with I/O module No.5.
PWM communication error
Communication is unavailable with PWM module.
Control FRAM error
Parameters can't be loaded from FRAM of control.
Parameter error(CONFIG)
A parameter value has an error.
Parameter error(PROG)
Pattern or segment parameter value has an error.
PWM calibration error
PWM calibration value is out of range.
Constant-value operation is running for Ch.1.
-
Program operation is running for Ch.1.
-
It is in Hold operation for Ch.1.
-
It is in Wait operation for Ch.1.
-
Loading parameters for Ch.1.
-
Constant-value operation is running for Ch.2.
-
Program operation is running for Ch.2.
-
It is in Hold operation for Ch.2.
-
It is in Wait operation for Ch.2.
-
Loading parameters for Ch.2.
-
●
Messages on operation screen
To Next Page
Loading...
