33
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Specific value
Time
Specific value
Target
setting
value
2nd target value
Start of fuzzy inference
1) Control brightness of LCD screen in 8 steps. Press “◀” to dim it and “▶” to brighten it.
2) Function to turn off the back light after set time in order to protect the LCD. Time can be set by
minute and set "0" to disable it. In the energy-saving mode, touch the screen to wake it up.
3) Select an operation type to recover from power failure.
4) Turn on/off buzzer for input and operation confirmations.
5) Use to limit the touch panel input. Only operation screen and move buttons enabled.
If password set in [System setting] – [System], enter the password to change it.
6) Use to limit entering to main menu. When trying to enter the main menu, password input box is
prompted if any. Set "0" to disable it.
7) Operation 2 screen is automatically switched by time setting.
8) Change the name of user-defined button. If the language is Korean,
use Caps to enter “Korea -> English upper case -> English lower case”.
If the language is English/Chinse, “English upper case -> English lower case” can be entered.
▶ Function setting
Parameter Constant-value control Program control
STOP
Stopped Stopped
COLD
Start operation with
existing setting value.
Start operation from the 1st segment.
HOT
Start operation from the segment that was selected before blackout.
Parameter Setting range Default
Screen brightness control
8 steps
Step 3
Energy-saving operation time 0-99 [min] 30 min
Recovery from blackout STOP, COLD, and HOT STOP
Beep sound Cancel, Set Setting
Touch input lock Cancel, Set Cancel
Main menu password 0-9999 0
Operation screen switch time 0-9999 0
Name of user-defined button Up to 14 characters User-defined button
[Function setting parameter]
●
Fuzzy function
It is to control over shoot using fuzzy inference and useful
for the followings.
- To start control at where target setting value and
measurements show big difference
- To reduce warming-up time
- Significant load change in normal operation
- Frequent changes of setting values
①
③
⑤
⑦
②
④
⑥
⑧
Fig. 47) Function setting
To Next Page
Loading...
