HANYOUNG NUX TD510 Series - Page 65

63
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Temperature
Time
Temperature
Time
Temperature
Temperature
Time
Time
I/S1 : Temperature PV2 operation setting
Operation range : 50 ± 10 (OC) setting
Direction of range : Ascending HYS operation
I/S2 : Temperature PV2 operation setting
Operation range : 50 ± 10 (OC) setting
Direction of range : Descending HYS operation
Temperature
Time
Temperature
Time
Temperature
Temperature
Time
Time
I/S1 : Temperature PV2 operation setting
Operation range : 50 ± 10 (OC) setting
Direction of range : Ascending HYS operation
I/S2 : Temperature PV2 operation setting
Operation range : 50 ± 10 (OC) setting
Direction of range : Descending HYS operation
Fig. 101 is an example of setting inner signal(I.S) NSV. Inner signal No. 1 - 3 and 8 are set with
temperature, NSV, and Within range so that the inner signal is turn on or off according to change of
current setting value(SV).
Fig. 102 is an example of setting inner signal No.1 - 3 and 8 with temperature, TSV, and Within range.
Based on TSV as a target setting value, the inner signal is turned on/off to show difference with NSV.
Fig. 103 is an example of setting inner signal No.1 - 3 and 8 with temperature, PV1, and Within range,
and Fig. 104 is an example of setting inner signal No.1 and 2 with temperature, PV2, and type to set
ascending/descending.
Fig. 101) Example of inner signal setting
(NSV)
Fig. 103) Example of inner signal setting (PV1)
Fig. 102) Example of inner signal setting
(TSV)
Fig. 104) Example of inner signal setting (PV2)