HANYOUNG NUX TD510 Series - Page 70

Programmable Temperature & Humidity Controller
68
1. DI 1 operation type
- Set function for DI 1 operation.
- Error : DI 1 operation is used as an error.
- Run/Stop : DI 1 error enables operation and release of it stops operation.
2. DI 2 operation type
- Set function for DI 2 operation.
- Error : DI 2 operation is used as an error.
- Hold : DI 2 error holds current operation and release of it cancels hold. (For program operation)
3. DI 3 operation type
- Set function for DI 3 operation.
- Error : DI 3 operation is used as an error.
- Step : DI 3 error forces transition from current segment to next one. (For program operation)
▶ Configuration type
Parameter Setting range Default
DI1 operation type Error and Run/Stop Error
DI2 operation type Error and Hold Error
DI3 operation type Error and Step Error
DI4 operation type Error and Run/Stop Error
DI5 operation type Error and Hold Error
DI6 operation type Error and Step Error
Parameter Setting range Default
DI input state Always and During operation Always
Buzzer ON time 0 - 9999 min 59 sec 0 S
Detection delay 0 - 9999 min 59 sec 0 S
[DI configuration type parameter]
Fig. 114) DI configuration type