81
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Screen for upgrading firmware and entering test mode. This screen is not available during operation.
To access this screen, the password is required. (Default password : 0)
▶Firmware upgrade
•You may not escape from this screen. You must reboot the display and control module.
•User attention is required for upgrading firmware so make sure to set the password.
Default password is "0". Upgrade files can be downloaded from "Hanyoung Nux" website. Do not change a file name
and place it in TD510_FWUP folder in the root directory of SD card to read it. If the firmware is upgraded, the
parameters are initialized.
Caution
Displays upgrade file name.
Set a password for accessing F/W pane.
Access firmware upgrade pane.
Test mode is to test calibration
before shipment.
Caution
Fig. 141) Firmware upgrade
Fig. 142) Firmware upgrade input pane
To Next Page
Loading...
