Hardi HC 9600 User Manual

4 - System setup
92
Swath Section Offsets
The Implement Offsets screen opens. On a typical HARDI® configuration, this screen may consist of up to three tabs:
• Implement tab.
• Liquid with Hardi Sprayer tab.
• Boom Height tab.
Implement tab
Implement Modeling:
Implement Type:
• Standard
• Hardi SafeTrack
μ
ATTENTION! For IntelliTrack sprayers, select
the “Hardi SafeTrack” option.
Hitch to Axle Distance:
Press to type in value.
Type in the measured value from Hitch of the
sprayer to the axle.
Implement Rear Hitch:
No relevant settings for HARDI® sprayers.
Option should remain unchecked.
Liquid with Hardi tab
Forward/Backward Distance from Hitch:
• Set distance between the hitch eye and the
nozzles.
Left/Right Distance from center line:
• For asymmetric booms. As HARDI® booms
are never asymmetric, this option must be set
to 0 ft. Left or Right selection does not matter.
Boom Height tab
Forward/Backward Distance from Hitch:
• Set distance between the hitch eye and the
nozzles.
Left/Right Distance from center line:
• For asymmetric booms. As HARDI® booms
are never asymmetric, this option must be set to 0 ft. Left or Right selection does not matter.
Configuration
Select Your Specific
Configuration
Offsets
Implement Offsets: Hardi Commander
Implement Liquid with Hardi Sprayer
Implement Modeling
Implement Provides a Rear Hitch
Hitch to Axle
Distance
Lateral Offset from Centerline
Left
Implement Type
Standard
Front Hitch to Rear Hitch
Implement Rear Hitch
Heading
Aggressiveness
Boom Height
Implement Offsets: Hardi Commander
Implement Liquid with Hardi Sprayer Boom Height
Forward/Backward Distance from Hitch
Left/Right Distance from Centerline
Left
Independent Section Offsets

Hardi HC 9600 Specifications

General

Brand	Hardi
Model	HC 9600
Category	Controller
Language	English