6 - Maintenance
6.21
Preparing the sprayer for use after storage
After a storage period, the sprayer should be prepared for the next season the following way:
1. Remove the cover.
2. Remove the support from the
wheel axle and adjust the tire pressure.
3. Wipe off the grease from hydraulic ram piston rods.
4. Fit the pressure gauges again. Seal with Teflon tape.
5. Connect the sprayer to the tractor including hydraulics a
nd electrics.
6. Check all hydraulic and electric functions.
7. Empty the tank of remaining an ti-freeze.
8. Rinse the entire liquid circuit on the sprayer with clean water.
9. Fill with clean water and che
ck all functions.
To Next Page
Loading...
Need help?
General
