Harman P35I - 4. Distribution Blower; 5. Feeder Body

36
P35i Fireplace Insert
Pellets or Corn/Pellet Mixture Only
Save These Instructions
3-90-775R15_04/13
4. Distribution Blower
Requiresnolubrication.
Keepthemotorwindingsandsquirrelcagefanfreeof
dust.Canbewipedcleanorvacuumed.
Toremovedistributionblower;
• Slidetheinsertbodyoutofthemountingframe.
• Locate the blower in the back of the unit. You'll
needtotilttheunitforwardforeasyaccess.
• Remove 8 tek screws using a 5/16" driver or
wrench.
8 screws
5. Feeder Body
Wipeorvacuumtoclean.
Useavacuumtoremovenesandsawdust.
Toaccessfeedercleanout;
• Slidetheinsertbodyoutofthemountingframe.
• Locatethefeedercoverfromtherightsideofthe
unit.
• Loosenthewingnutapproximately3/4oftheway
outonthestud.
• Pulloutonthebottomofthecoverthenliftupward
toremove.
• Notice the deector shield is sitting loose in the
feeder.Itcanberemovedbyrollingitfromunder
thepusherarmshaft.Justbesureitisrepositioned
properly.
• Whenre-installingcover,tightenthewingnuthand
tightonly.
Loosen wing nut to remove cover
Vacuum nes from this area