Harman P35I - 6. Igniter

37
Pellets or Corn/Pellet Mixture Only
P35i Fireplace Insert
Save These Instructions 3-90-775R15_04/13
6. Igniter
Vacuumtoclean.
Whenevercleaningburnpotairchamber.
Toremoveigniter;
• Loosenwingscrewsandremovecoveronfrontof
burnpot.
• Usinga5/16"wrench,removethetwoblackscrews
above the cleanout. The igniter and bracket are
nowfree.
• Slidetheinsertbodyoutofthemountingframe.
• Locatethepaleblueandyellowwiresenteringat
thebottomofthefeederbody.
• Removewiretiesasneededtoloosentheigniter
wires.
• Pulltheigniterandbracketoutfromthefrontuntil
thewiredisconnectsareaccessible.
• Wheninstallingigniter,reversethesestepsandbe
surethattheplasticcoatedwiresarepulledallthe
waytotherearofthefeeder.
• Re-tieallwiresclearofallhotormovingparts.
This hole in the feeder body is where the igniter wires pass
through to the burn pot.
FEED MOTOR
This shows the igniter and bracket removed from the
burn pot. Missing in the illustration is the wires from
the igniter which run through the burn pot air chamber.
Only the rst few inches of the wires are insulated for
high temperatures. These insulated wires are all that
can be inside the feeder or burn pot.