HFS6801+ Installation and Operation Manual 17
Chapter 2: Installation
2. Remove the module from the 6800+ frame.
Figure 2-3. Buttons on a Typical Card Edge
3. Set the Hex switch to F.
4. While pressing the Navigation toggle switch down, reinsert the
module into the frame and then release the Navigation toggle
switch.
5. Perform a Discovery operation to discover the module, as described
in “Discovering a DAV6800+ Module” on page 30.
Information about discovering modules can also be found in
your CCS software application manual or online help. (If you
cannot discover the device, see “Manually Adding a Device to
the Discovery or Network Folder” on page 21.)
Mode select rotary
(hex) switch
Navigation toggle
switch
To Next Page
Loading...