RF-5800H 125-WATT COMMUNICATION SYSTEM
SAFETY SUMMARY
vii
SAFETY SUMMARY
1. INTRODUCTION
All operators and maintenance personnel must observe the following safety precautions during operation and
maintenance of this equipment. Specific warnings and cautions are provided in the manual and at the end of this
Safety Summary. Warnings, Cautions, and Notes appear before various steps in the manual and will be used as
follows:
• WARNING – Used when injury or death to personnel and damage to equipment is possible
• CAUTION – Used when there is a possibility of damage to equipment
• NOTE – Used to alert personnel to a condition that requires emphasis
2. PERSONNEL AND EQUIPMENT SAFETY
Basic safety precautions consider factors involved in protecting personnel from injury or death. Electrical,
mechanical, electromagnetic radiation (EMR), material, or chemical hazards are the most common types of
hazards found in electronic equipment. The following are types of hazards that may exist:
ELECTRICAL – Hazardous voltage and current levels may exist throughout the equipment. Contact
with these hazards could cause electrocution, electrical shock, burns, or injury due to
involuntary reflexes of the body.
MECHANICAL – Mechanical hazards are created when heavy assemblies and components must be
removed and replaced. Moving parts (such as fan blades) and hot surfaces are
potential mechanical hazards.
THERMAL – Burn hazards may exist in the equipment that could cause personal injuries and/or
serious equipment damage. Internal surfaces of the equipment may be in excess of
65°C, the point at which personnel could be burned. Extreme caution should be used
when working with any hot assemblies (for example, power supply or power amplifier
assemblies). Physical injury or damage may result to personnel and/or equipment as a
result of a reflex action to a burn.
CHEMICAL – Chemicals or materials used for servicing the equipment may present potential
hazards. Many chemical agents, such as cleaners and solvents, may be toxic, volatile,
or flammable. If used incorrectly, these agents can cause injury or death.
EMR – Overexposure to electromagnetic radiation resulting from amplified radio frequencies
that may produce a health hazard.
3. OPERATIONAL AND MAINTENANCE SAFETY GUIDELINES
Good safety discipline is critical to prevent injury to personnel. All other safety measures are useless if personnel
do not observe the safety precautions and do not follow safety disciplines. Once aware of a hazard, personnel
should ensure that all other personnel are aware of the hazard. The following basic safety disciplines are stressed:
a. Read a procedure entirely before performing it. Personnel must always perform each assigned task in a
safe manner.
b. Prior to applying equipment power after maintenance, personnel must ensure that all unsecured hand
tools and test equipment are disconnected from the serviced/maintained equipment and properly stored.
To Next Page
Loading...
Need help?
General
