11
Strap attachment and removal 9, 10, 11
Place the main body of the strap clip over one of the camera’s strap lugs. Press the tip of the
clip towards the camera while pulling back on the strap so that the clip slides over the lug
and locks into position. To remove the strap, lift the clip locking plate high enough to be able
pass over the camera lug. Slide the clip in the direction away from the strap until it is free.
Accessory rail 8
The camera has an accessory rail on the left hand side for the spirit level and the adjustable
flash shoe (for small flash units).
Winding crank 6, 7
The winding crank can be removed. Push the catch lever downwards while rotating the
crank counter-clockwise and pull the crank straight out from the shaft. To attach it, align
the small triangular index mark against the red dot on the camera body. Keep the crank
pushed against the camera while turning it clockwise until the larger triangular mark is
aligned with the red dot where it will click into position.
6
7
9
8
10
11
To Next Page
Loading...
Need help?
General
