64
Default approval status
By default, the system assigns an initial approval status for each
new shot based on an analysis of the distribution of exposure levels.
However, you might choose instead to override this system and have
all new shots assigned either as green or yellow, regardless of the
exposure analysis results. A typical strategy could be to assign all
shots to yellow and then review all of the shots later and promote
only the best ones to green status. At the same time you might
demote the most doubtful shots to red status.
To change the default status assigned to each new image:
1. Press the MENU button.
2. Press to navigate down and select the Storagelevel.
Press and then to navigate down and select Default
Appr. level.
3. Use the
+
or
–
button to step through the available settings
until the default status you wish to use is shown:
• Auto: works as described in Standard Instant Approval
Workflow .
• Green: gives all new images a green status, regardless of the
exposure warning.
• Yellow: gives all new images a yellow status, regardless of the
exposure warning.
4. Press the menu (EXIT) button to exit the menu system and
keep the setting.
1
2
3
4
Note
Understand the difference between
changing the Default Approval Status
(which affects all new captures) and
manually changing the Approval Status
of individual captures.
To Next Page
Loading...
Need help?
General
