Hasselblad 503CW - Page 77

77
Hasselblad 503CW plus winder CW
Exposure Cable 503
All Hasselblad EL models
All Hasselblad EL models except ELD
Adapter EL
Exposure Cable EL
Pinhole
For use with lenses/cameras with no shutter. Intended primarily for use in a studio environ-
ment where complete darkness can be achieved and exposures made accordingly (also
useful for ‘light painting’). In this mode the CFV uses the exposure time (as well as other
required stages in a capture sequence) set in the Capture Sequence dialog. The CFV can be
triggered either via the START (MENU/EXIT) button or from Phocus (see later section for full
description of Capture Sequence settings procedure).
ELX
Forusewith500EL/ELMand500/553ELXmodels:
• MakeanELX setting.
• TheExposure Cable EL (supplied) should be connected.
• Allexposurestimes,includingtheBsetting,functioncorrectlywithouthavingtoalterthe
“Exposure Time” setting.
• Rapidsequenceshotsarenotpossible.
• UsetheAdapter EL (supplied) to provide the necesssary extension beyond the motor housing of
the EL models for battery attachment. It is attached to the CFV in the same manner as a battery,
and the battery itself is then attached to the adapter as in the illustration.
ELD
ForusewithELDmodels:
• MakeanELD setting.
• ABsettingexposurecanbemadebychoosingthe‘Bulb’inthe‘ExposureTime’setting.The
maximum exposure time remains at 32 seconds however.
• Onlythesingleshotfunction(AorASmodecamerasettings)shouldbesetonthecamera.
Rapid sequence shots are not possible.
• UsetheAdapter EL (supplied) to provide the necesssary extension beyond the motor housing of
the EL models for battery attachment. It is attached to the CFV in the same manner as a battery,
and the battery itself is then attached to the adapter as in the illustration.
Winder CW
Forusewith503CWmodels:
• MakeaWinder CW setting.
• IfyouwanttocontrolthecamerafromPhocus,connectthe‘Exposurecable503´between
the CFV and the Winder CW as in the illustration.
• Donotusethewinderatrapidsequencesetting.
Model setting variations
Look in the list below for the camera model you are using and make the appropriate set-
tings change. Don’t forget to change the setting if you change camera model!
The exposure time set on the CFV sets the maximum length of exposure. The default set-
ting is 1/8 sec and this is the setting that can be kept for all exposures from 1/8 sec through
1/2000sec. However, this setting should be changed in accordance with the time required
if it exceeds 1/8 sec. Times of up to 32 seconds can be set.
If you prefer, you can connect the ‘Flash sync input cable’ between the lens PC socket and
the CFV which allows you to retain the default setting of 1/8 second while still being able to
use exposure times longer than 1/8 second. This method also allows the use of the B setting.