Hatz 1B30E - Page 38

Transport, installation and commissioning 1B30E, 1B50E / 02 - Rev. 01
38
HATZ
Manual
Overview
I
0
0
I
1 Starting key
2 Oil pressure indicator
3 Charge control
Ignition lock
0 Off
I Operation
Procedure
Step Activity
1 Insert the starting key all the way and turn to position "I".
The oil pressure indicator(2) and charge control(3) light up.
2 Leave the starting key at position "I" until you hear the electrical
fuel feed pump switch off (approx. 10seconds).
3 Turn the starting key back to position "0".
Note:
Carry out steps 2 and 3 several times to press the air out of the
fuel system.
4 After bleeding, multiple start attempts with the starter are neces-
sary to start the engine. Start the engine (see chapter 7.3 Start-
ing the engine, page 40)