Hatz 1B30E - Page 82

Faults 1B30E, 1B50E / 02 - Rev. 01
82
HATZ
Manual
The light flashes three times in a row for each error. If two or more errors are
active, these are flashed immediately afterwards. To repeat, turn the starting
key to position "0" and then back to position "I". The flash code is deleted au-
tomatically if the error does not reoccur within two operating cycles (= start/
operation/stop).
Flash code table
Flashing signal Possible causes Remedy Chapter
1
Area affected:
Engine oil pres-
sure
Engine oil pressure
too low.
Check the oil level. 7.5 Check
the oil level,
page 45
2
Area affected:
Overtemperature
Engine tempera-
ture is too high.
Clean the cooling
air area.
8.2.7 Clean-
ing the cool-
ing air area,
page 65
Oil temperature too
high.
Reduce the engine
load.
3
Affected area:
Charge control
Faulty voltage con-
troller.
Contact HATZ ser-
vice.
Battery voltage too
high.
Contact HATZ ser-
vice.
Battery voltage too
low.
Check the electri-
cal equipment and
its components or
contact Hatz ser-
vice.
Speed adjustment
is faulty.
Contact HATZ ser-
vice.
Supply voltage for
sensors is faulty.
Check the cabling.
4
Area affected:
Analog setpoint
or CAN communi-
cation
Cabling is faulty. Check the cabling.
Speed adjustment
is faulty.
Contact HATZ ser-
vice.
5
Area affected:
Ambient pressure
sensor
Sensor is faulty. Contact HATZ ser-
vice.