Hatz 1B30E - Page 87

1B30E, 1B50E / 02 - Rev. 01 Faults
HATZ
87Manual
7 Diagram of starting procedure
Procedure
Step Activity
1 Insert the starting key(1) all the way and turn to position "I". The
oil pressure indicator and charge control light up.
2 Assume a sturdy position. The surface you are standing on must
not be slippery.
3 Secure lightweight devices with your foot.
4 Pull the grip(5) with the rope through slowly and let it run back
in. This activates the electric fuel pump for 10seconds. If the
engine does not start within these 10seconds, repeat the proce-
dure.
5 Slowly pull out the grip(5) with the rope until you encounter
slight resistance.
6 Let the rope run back in to be able to use the entire rope length
for the starting procedure.
7 Hold the grip with both hands.