To Next Page

To Previous Page

Installing an Internal Plug-n-Play Modem 7

Using SETCOM16

Installing the Modem Using SETCOM16:

The following steps outline modem installation using the

INSTALL.EXE program to configure the modem.

1. Before you open your computer to install the modem, unplug it

from the power outlet.

2. Select an empty slot and remove the slot cover plate.

3. Hold the modem by the top and gently slide it into the slot.

4. When you turn on your system, start at the DOS prompt, insert

the Driver and Utilities diskette or CD. Get the A: or D: prompt. Type

INSTALL.EXE. This will install the SETCOM16 program to the hard

drive.

5. Follow the screen instructions to configure your modem for COM

ports 1-4.

Note: If you need to change the configuration of the modem later,

you will need to type: C:\SETCOMM\SETCOM16.EXE. See below

for more detailed information.

Changing the modem configuration using SETCOM16:

Step 1: From the SETCOMM directory on your hard drive,

(usually C:\SETCOMM) type: SETCOM16. Press

Enter.

Step 2: Follow the instructions above to change the

configuration. The AUTOEXEC.BAT file updates

automatically.

Note: If your DOS-based programs are not communicating properly

with the modem, make sure the SETCOM16 utility is configuring the

Hayes Modem User Manual

Questions and Answers: