Installing an Internal Plug-n-Play Modem 11
6. To manually assign the resources, select the last Basic
configuration available (typically Basic configuration 0006).
7. If the I/O range reports a conflict double, click on Input/Output
Range. The Edit Input/Output Range dialog box will appear.
Select one of the following values that does not report a conflict:
Value COM Port
03F8-03FF COM 1
02F8-02FF COM 2
O3E8-03EF COM 3
O2E8-02EF COM 4
8. Press OK to accept the value.
9. If the Interrupt Request is reporting a conflict, double-click on
Interrupt Request. The Edit Interrupt Request dialog box should
appear.
10. Scroll through the interrupts until you find one that doesn’t report
a conflict.
11. Press OK to accept the value. Then Press OK to close the
window. A warning window will display to verify that you want to
create a forced configuration. Press Yes.
Note: If you find you don’t have enough resources available, you
may need to disable a COM port. See the “Disabling a COM (Serial)
Port” section on page 19.
To Next Page
Loading...