HBM DMP41 - Page 69

Configuration
Configuring measurement channels in setting mode
DMP41 A03470_07_E00_00 HBM: public 69
7.2.3 Zeroing and taring (Zero/Tare)
Zeroing and taring using the quick configuration bar in measuring
mode
Selected channels are set to zero or tared with Zero or Tare, i.e. the
currently measured zero value or tare value is applied (in mV/V).
Quick configuration bar
Zeroing and taring using an edit field in setting mode
Edit fields for the zero value and the tare value:
S Zero value
S Tare value
3
1
2
4
Applies the adjacent electrical value as the zero value
Applies the adjacent electrical value as the tare value
Applies the adjacent (scaled) physical value as the zero value
Any unit (set in Scaling)
1
2
3
4