HBM PAD4002A - English; Table of Contents

2 A4243-1.0 HBM: public PAD4002A
English
1 Safety instructions 4........................................
2 Markings used 8............................................
2.1 Symbols on the device 8......................................
2.2 The markings used in this document 8..........................
3 Structure and mode of operation 10...........................
3.1 Structure of the electronics 11..................................
3.2 Signal conditioning 12.........................................
3.3 Adaptive interference suppression 13............................
3.4 Inputs and outputs 14.........................................
3.4.1 Trigger function 14............................................
3.4.2 Filling and dosing 15..........................................
3.4.3 Limit value function 15.........................................
3.4.4 Extreme value functions 15....................................
4 Conditions on site 16........................................
5 Mechanical installation 17....................................
5.1 Important precautions during installation 17......................
5.2 Mounting 18..................................................
5.3 Dimensions 19...............................................
6 Electrical connection 20......................................
6.1 Cable laying 20...............................................
6.2 Pin assignment 20............................................
6.3 Supply voltage 23.............................................
6.4 Effect of the connecting cable on the thermal characteristic of
sensitivity 24.................................................
7 Interfaces 27................................................
7.1 RS‐485 4‐wire interfaces (UART) 27............................
7.2 CANopen interface 29.........................................