WE2111
12 A3983-1.0 en/de/fr
4 Calibration labels and sealing
The WE2111 calibration is implemented digitally. The
results are saved power failsafe.
Settings that change the calibration are only possible in
the setup mode "Full" (password protection
recommended). This also changes the status of the
calibration counter and can therefore be subsequently
recognized. In addition, it is possible to restrict the
access to the Full setup mode so that access is only
possible after the button on the rear is pressed (Fig. 4.1).
The button is covered by a panel and can be protected
by a suitable label, lead seal or seal.
Hidden button
(cover removed)
Fig. 4.1 View from rear, fastener brackets swivelled out
To Next Page
Loading...
