WE2111
A3983-1.0 en/de/fr 27
9 Mechanical installation
Conditions on site
S Protect the device from direct contact with water.
S Protect the device from moisture and weather such as
rain or snow. The device degree of protection is IP20
(DIN EN 60529), the front plate degree of protection
is IP66.
S Do not expose the device to direct sunlight.
S Protect the device against impact/shock loads and
strong vibrations.
S Comply with the maximum permissible ambient
temperatures and maximum humidity figures stated in
the specifications.
Installation orientation
The device can be mounted in any position.
Installation
The WE2111 can either be used as a desktop device,
e.g. with the option 1-WE2111-ZT (table stand), or as a
built-in device. Mounting is identical in both cases, the
housing fits in any standard device recess as per DIN
43700 (138mm x 67mm).
"
Push the housing through the recess.
"
Swivel the four fastener brackets (1) on the corners
out by 90° to 180°, depending on the desired or
necessary fastening position (Fig. 9.1).
"
Hand-tighten the screws (2) (Fig. 9.1).
To Next Page
Loading...
