HBM we2111 - Calling the Setting Menu; Implementing General Settings

WE2111
30 A3983-1.0 en/de/fr
10.2 Calling the setting menu
"
Press the button for several seconds.
SAFE is displayed.
"
Press the button again (briefly).
FULL is displayed.
"
Press the button.
The following are displayed in sequence: SEtUP,
firmware version (e.g. P60c), calibration counter
(e.g. C00008) and buiLd.
10.3 Implementing general settings
(decimal places, nominal (rated)
range, unit)
The display must show buiLd before the following
settings can be made.
"
Press the button twice.
dP is displayed.
"
Press the button.
000000 is displayed.
"
Press the button until 0000.00 is displayed.
The number of decimal places is then set to two
places.
"
Press the button.
dP is displayed (decimal point).