42
Audio Tab:
Phantom Power (+48V): This setting determines whether phantom power (+48V) is enabled (On)
or disabled (Off) for all four Inputs.
Important: Only enable phantom power if your microphone requires it. Most dynamic
microphones and ribbon microphones do not require phantom power, while most condenser
microphones do. Consult your microphone's documentation to find out whether it needs
phantom power.
XLR Ground Lift: This setting determines whether the XLR ground lift feature is enabled (On) or
disabled (Off). Use this feature to reduce hum or noise in the signal from the XLR Outputs.
1/4 Output Level: This setting determines the output level of the 1/4" Outputs. When set to
Line, the output level will be +18 dBu. Use this setting if you are connecting HeadRush
Looperboard to a full-range, flat-response amplifier, PA speaker, mixer or audio interface. When
set to Amp, the output level will be +6 dBu. Use this setting if you are connecting the
HeadRush Looperboard to a traditional guitar amplifier.
USB Audio Tab:
Enable: This setting determines whether or not HeadRush Looperboard is sending a USB audio
signal over a USB connection. Set to On to enable sending of the USB audio signal with the
selected Sample Rate. Set to Off to disable the USB audio signal. (To change the Sample Rate,
set USB Audio to Off first, select the correct sample rate, set USB Audio to On again, and
restart your DAW.)
Sample Rate: This setting determines the sample rate of the USB audio signal: 44.1 kHz, 48.0
kHz, 88.2 kHz or 96.0 kHz. Remember to select the same sample rate as the one in your DAW.
Also, set it before opening your DAW.
To Next Page
Loading...
