30
80-23024 Issue 3r1 HEBER
Unless you live in a very hot country or plan to have the Multisystem inside a cabinet or otherwise
somewhere with limited airflow, you can use the 3.3v connection. 3.3v will provide plenty of
airflow to cool the DE10-nano and Multisystem board.
You are almost done, just a few more steps…
Make sure to tuck the USB Hub cable behind the 3D printed section shown above. This is important
as it allows the back panel to be inserted and removed without catching on the USB cable.
Note, the USB cable can be supplied in white or black.
To Next Page
Loading...