HEIDELBERG Speedmaster CD 102 - Capacitive Sensor Automatic Pile Transport Changeover

GR FS9040012000000000 GR FS9040013000000000
Maintenance
confidential
D.3.14
5.4 Capacitive sensor ”Automatic pile transport changeover”
1
Fig. 16 Place of installation of the ”Automatic
pile transport changeover” sensor
Place of installation
1 Capacitive sensor ”Automatic pile transport
changeover”
The capacitive sensor ”Automatic pile transport
changeover” is installed at the end of the feed table,
before the pile.
5.4.1 Cleaning the capacitive sensor
1
Fig. 17 Clean the sensor
1 Capacitive sensor ”Automatic pile transport
changeover”
Maintenance point description
Maintenance inter-
val
15 000 000 prints, or twice a
year
Maintenance loca-
tion
Center
Accessibility of the
maintenance points
Remove the pile from the
feeder. Secure the press
against start-up.
Number/type/main-
tenance work
Clean the sensor.
Tool Clean, fluffless cloth; brush
Cleaning solution See ”Approved cleaners”.
Tab. 10
UTKFS9040004000000000008