5 – 4 HEIDENHAIN Technical Manual TNC 426, TNC 430
9044 Reading the spindle coordinates
(Format 0.0001°)
280 476-03 6 – 182
9050 Conversion of binary numbers → ASCII 7 – 180
9051 Conversion of binary numbers → ASCII 7 – 181
9052 Conversion of ASCII → Binary 7 – 182
9053 Conversion from binary → ASCII/
hexadecimal
7 – 182
9054 Conversion from ASCII/hexadecimal →
binary
7 – 183
9055 Local time 6 – 332
9060 Status of M functions 280 476-06 6 – 284
9061 Status of non-modal M functions 280 476-09 6 – 284
9066 Status of HEIDENHAIN inverter 280 476-09 6 – 172
9070 Copy a number from a string 7 – 157
9071 Find the string length 7 – 158
9080 Clearing the small PLC window 6 – 251
9081 Interrogating the status of the small PLC
window
6 – 251
9082 Showing a string in the small PLC window 6 – 252
9083 Showing a moving-bar diagram in the small
PLC window
6 – 254
9085 Display PLC error messages 6 – 289
9086 Erase PLC error messages 6 – 290
9087 Status of PLC error message 6 – 290
9088 Displaying the M functions 280 474-03 6 – 239
9089 Control in operation 6 – 240
9090 Selection of a line in the pallet table 6 – 306,
6 – 309
9091 Finding the line number of a tool in the tool
table
280 474-03 6 – 417
9092 Searching for an entry in the tables
selected for execution (.T/.D/.TCH)
6 – 405
9093 Read data from tables selected for program
(.T/.D/.TCH)
6 – 407
9094 Writing data into a tool and datum table 6 – 408
9095 Select active line in configuration file 6 – 43
9096 Erasing a line in the tool table 6 – 409
9097 Selecting the geometry description 280 476-03 6 – 66
9098 Finding the active geometry description 280 476-05 6 – 67
Module Function SW Vers. Page
To Next Page
Loading...
