43
SBS Only: Please enable it when you issue cards with software programed by SDK.
This option disables printer device driver.
Safe Head Heat: Set not to print if the print head is overheated.
Cleaning Warning: Set to show the ‘Do cleaning’ message periodically
Use USB Serial: When CP55 is connected to USB, it transmits the USB serial number
to PC. Default is the same number used by all CP55. Please set this option when you
use multiple CP55 printers connected to 1 PC via USB. It enables unique serial
numbers for each USB.
Mag. Head Position: CP55 can install the magnetic encoder on lower side of a card.
Card Out: Set the way to eject cards.
Error Card Out: Set the way to eject error cards.
Auto Front Card In: Set to input a card automatically if the front card-in sensor
detects a card. It is used for the KIOSK model.
Auto Rear Card In: Set to input a card automatically if the rear card-in sensor detects
a card. It is used for the KIOSK model.
Dump Mode: It records log data to inspect the operation of printer.
User Mag. Current: The default current value when the user selects to use the
defined value when magnetic encoding
Mag. Write Mode: You can order the way how to encode magnetic stripe.
“L:A, H:I”: encodes 3 tracks at once for LoCo card and encodes at twice by dividing 1,3
and 2 track for HiCo card.
Magnetic Start Position: Set the start position of magnetic stripe when you encode.
Mag. Write Speed: You can order the speed to encode magnetic stripe.
Flipper Cover Open: Set to notify the Flipper cover is opened or not. [Check / Ignore]
UART Baud Rate: To set the communication speed (Baud rate) of the external device
connected to Printer by serial.
Card In Speed: set the speed of inputting a card
Card Move Speed: set the speed of moving a card
Card Eject Speed: set the speed of ejecting a card
Card In Delay: set the delay time to operate the hopper motor.
Stability Interval: select stability or faster speed. Default is ‘on’, stability.
To Next Page
Loading...