To Next Page

To Previous Page

configured with this)

◆Clock setup: Through this parameter, the meter time can be set to the actual time.

However, this time can be reset after the constant power failure of the meter.

◆Hourmeter reset to zero: This parameter can reset the hourmeter, hourmeter can

only be the accumulated working time of the instrument; (to configure this parameter,

enter the correct password first)

◆Percentage of liquid crystal contrast: the contrast can be adjusted by this

parameter (this parameter cannot be adjusted to 0 or 100%); (to configure this parameter,

enter the correct password first)

◆Percentage of pump power forbidden: when the meter shows the power through

this parameter, the pump lift and tilt are forbidden to work; (to configure this parameter,

enter the correct password first)

◆Password input: enter the password here. It is necessary to enter the password

again before parameter setting to modify the parameters. (default password: 000001)

◆New password: the password can be modified by this parameter after entering the

password;

◆Drive motor controller monitoring: under this menu, monitor the status of the

walking controller;

◆Pump motor controller monitoring: under this menu monitor pump controller

status.

4.2.4 ZAPI instrument

4.2.4.1 Panel position

HELI CPD15 Service Manual

Questions and Answers: