Ch. 11 A.C.GENERATOR/STARTING CLUTCH
11-6
Remove the 2 springs from the ratchet cover.
Do not remove the volute spring from the recoil
starter cover unless the spring is broken. If the
volute spring is removed from the recoil starter
cover, it should be replaced with a new one.
Remove the starter grip rubber.
Disassemble the starter grip and rope.
Installation
Install in reverse order of removal procedures
Caution
First before installing the drive pulley must
establish 2 1/2 of the pressures
transferred to pressure springs.
To Next Page
Loading...
