Ch. 1 GENERAL INFORMATION
1-1
Symbols and Marks ………………………1-1 Specifications …………………………..1-9
General Safety ……………………………...1-2 Locking Torque ………………………..1-10
Attention on operation ...………………….1-4 Troubles Diagnosis …………………...1-12
Symbols and Marks
Symbols and marks are used in this manual to indicate what and where the special service
is needed. In case supplemental information of procedures is needed for these symbols
and marks, explanations will be added to the text instead of using the symbols or marks.
Warning
Means that serious injury or even death may result if procedures are
not followed.
Caution
Means that equipment damages may result if procedures are not
followed.
Engine oil
Limits to use SAE 10W-40 API SG class oil. Warranty will not cover
the damage that caused by not apply with the limited engine oil.
Grease Chassis grease is recommended.
Gear oil
Gear oil serials are recommended. (Gear oil SAE 80/90 is
recommended )
Locking
sealant
Apply sealant; medium strength sealant should be used unless
otherwise specified.
Oil seal Apply with lubricant.
Renew Replace with a new part before installation.
Brake fluid Use recommended brake fluid DOT4.
Special tools Special tools
To Next Page
Loading...
