HERMOS LFM LP Reader - Page 77

Protocol description ASCII, SECS/HSMS
Customer manual
Version 1.2
LFM LP Reader 15.01.2019
Page 77 of 119
HERMOS AG
Gartenstrasse 19 Tel. +49(9279) 991-0
D-95490 Mistelgau Fax. +49(9279) 991-100
"ECID_38" Parameter 38 Test after software reset
"ECID_40" Parameter 40 Transponder load duration (write-mode)
"ECID_41" Parameter 41 Delay time between read cycles
"ECID_42" Parameter 42 CarrierIDOffset
"ECID_43" Parameter 43 CarrierIDLength
"ECID_44" Parameter 44 FixedMID
"ECID_45" Parameter 45 MIDFormat
"ECID_54" Parameter 54 SWITCHTUNEON
"ECID_55" Parameter 55 SWITCHTUNEOFF
"ECID_56" Parameter 56 SWITCHTESTON
"ECID_57" Parameter 57 SWITCHTESTOFF
"ECID_58" Parameter 58 Push Button switch status (read only)
"ECID_80" Parameter 80 Auto adjust value antenna port 1 (read only)
"ECID_97" Parameter 97 Default protocol (read only)
"ECID_98" Parameter 98 Protocol change allowed
"ECID_99" Parameter 99 Customer Code
Header attribute definitions:
"HeadStatus“ Current state corresponds to "OperationalStatus"
"HeadID“ "01" ID of first antenna port
Where used S5F1
ATTRVAL Format: A[max4]
Value of the specified attribute.
CIDRW-attribute definitions:
"Configuration” Number of antenna ports „01“
"AlarmStatus” Current CIDRW sub-state of the ALARM
STATUS
"0" …NO
"1" …ALARMS
"OperationalStatus" Current CIDRW sub-state of IN OPERATION
"IDLE”
…
reader in REST mode
"BUSY”
…
reader is busy
"MANT"
…
maintenance mode
"SoftwareRevisionLevel" Revision (version) of the software - maximum 8 bytes
"SERIALNUM" serial number string (max 15 bytes)
"HARDWARE" String of the hardware release (10 bytes max.)
"SELF_TEST_RESULT" Returns the result of the last self-test. A self-test can be
triggered by message S18F13 using SSCMD.
"MANUFACTURER" String from the manufacturer „HERMOS“