rubber and cap O-ring (5) are in good
condition.
•
Start the engine and let it idle for 2-3
minutes. Stop the engine and ensure that the
oil level is at the upper level mark on the oil
level dipstick with the vehicle upright on flat
level surface. Ensure there are no oil leaks.
At draining: 0.70 litre
•
Fill crankcase with the recommended grade
of oil:
At engine disassembly: 0.80 litre
•
Install the oil level dipstick.
•
Install the oil strainer screen, spring and oil
strainer screen cap. Install the drain plug.
(3) Spring (4) Oil strainer screen (5) O-ring
5
3
4
•
Park the vehicle on its main stand.
•
Stop the engine and wait for 2-3 minutes.
Final Drive Oil Replacement
The final drive oil should be replaced as per the
maintenance schedule. Replacement requires
mechanical skill. It is suggested to get it replaced
by authorised Hero MotoCorp workshop.
•
Start the engine and let it idle for 3-5 minutes.
(1) Check bolt (2) Drain bolt
2
1
CAUTION
!!
•
Engine oil quality is the chief factor affecting
engine service life. Replace and top-up the
engine oil as specified in the maintenance
schedule (pages 49).
•
When running in very dusty conditions, oil
changes should be performed more frequently
than specified in the maintenance schedule.
•
Used engine oil may cause skin disease if
repeatedly left in contact with the skin for
prolonged periods. Although this is unlikely
unless you handle used oil on a daily basis,
it is still advisable to thoroughly wash your
hands with soap and water as soon as
possible after handling used oil.
•
Please dispose used engine oil in a manner
that is compatible with the environment. We
suggest you take it in a sealed container to
your local recycling center or service station
for reclamation. Do not throw it in the trash
or pour it on the ground or down a drain.
56
To Next Page
Loading...
