•
Park the vehicle on level surface.
•
Turn the adjusting nut in direction (A) to
advance switch timing or in direction (B) to
retard switch timing.
•
Adjust the headlamp beam vertically by
rotating the screw. Rotate the screw
clockwise (A) for downward adjustment and
anticlockwise (B) for upward adjustment of
headlamp beam.
Headlamp is factory pre set. However in case
of adjustment required, please follow the steps
as given below :
HEADLAMP FOCUS ADJUSTMENT
•
Headlamp focus adjustment is done by the
headlamp adjusting screw (1) located below
headlamp.
1
2
A
B
(1) Stop lamp switch (2) Adjusting nut
(A) Advance (B) Retard
WARNING
!!
An improperly adjust headlamp may blind
oncoming rider/driver or it may fail to light the
road for a safe distance.
1
(1) Adjusting screw
(A) Clockwise (B) Anticlockwise
A
B
CATALYTIC CONVERTER
This vehicle is equipped with a catalytic
converter in the muffler.
A defective catalytic converter contributes to
air pollution and can impair your engine’s
performance.
•
Always use unleaded petrol. Even a small
amount of leaded petrol can contaminate
the catalyst metals, making the catalytic
converter ineffective.
The catalytic converter contains noble metals
that serve as catalyst, promoting chemical
reactions to convert CO and HC in the
exhaust to CO and H O (water vapour).
2 2
Follow these guidelines to protect your
vehicle’s catalytic converter.
51
To Next Page
Loading...
