2.2.3. Connector use
•
DO NOT attempt to force open a connection by pulling on the cables or by twisting the connectors in any way. Doing so can loosen the
connectors' shells, or even damage the contacts.
•
If the connector's shell is accidentally pulled off, stop using the connector and contact Hesai technical support.
•
DO NOT attempt to assemble the connector's shell and cable collet; DO NOT connect a connector without its shell. Doing so may damage
the lidar's circuits.
•
Before connection, check the pins on the socket and the holes on the plug. If bent pins or damaged holes occur, stop using the connector
and contact technical support.
•
For further troubleshooting, please contact Hesai's technical support or obtain work instructions from the connector manufacturer.
•
The connector supports at least 1000 mating cycles. Exceeding this limit may result in connector damage.
-24-
To Next Page
