USER MANUAL | NOVA TRANSMITTERS
16
6.4 Quickset/Programming mode
In most cases, the snail-rabbit toggle switch is present so as to change between slow and fast speed levels of the joystick.
However when the transmitting unit has another toggle switch/push buttons with “+” and “-“ labels, it is possible to manually
change the slow speed levels for each joystick in real time, so as to adapt the application’s response to the load and precision
needs required at that point in time.
In order to activate this functionality, the user has to:
1. Switch OFF transmitter and remove black key cap.
2. Insert red key cap and turn the key to “I” position to switch on the transmitter. An acoustic signal is heard.
3. Turn the key to ‘P’ position to activate ‘Programming’ mode and keep holding the “Start” button down for 2 seconds.
4. In order to set the minimum speed for a function, slowly move the joystick until it reaches the point when the safety DK is
activated. Hold the joystick in this position and press the ‘-‘ or ’+’ buttons to reduce or increase the speed, respectively.
5. In order to set the maximum speed, move the joystick until its maximum position is reached and press the ‘-‘ or ‘+’ buttons to
reduce or increase speed.
N.B. Ensure that the speed of only one function is programmed at one go. Whenever a speed setting is completed, wait for
approx 10 seconds before disconnecting the transmitter so as to make sure that the correct values are stored in the system.
N.B. The “Snail” and “Hare” functions are independent to each other, thus if the speed of the function “Snail” is to be set, this
has to be selected beforehand.
6. When all required joysticks speeds have been set, switch off transmitter by turning the red key cap to the ‘0’ position.
7. Replace red key cap with black key cap and switch on transmitter to resume operation.
To Next Page
Loading...
