HETRONIC NOVA XL - Technical Specification Transmitter Nova L 2.4

USER MANUAL | NOVA L 2.4
3
Transmitter Specifications
Transmitter NOVA L 2.4
Housing
Ergonomically designed Impact Resistant Polymer Composite
Environmental Protection
IP 65 (Exceeds Nema 12/13)
Weight
~1.8kg (3.96lbs) depending on configuration
Dimensions
Height: 264 mm
Width: 151 mm
Depth: 213 mm
Antenna
Internal as default, external via TNC connector
Power Supply
3.6V NiMH rechargeable battery pack or
5V to 30V via cable control
Diagnostics
Status LED for operation and standard/advanced low battery
detection
Battery Operation Time
Min 12 hrs continuous transmission*
Control Configuration
2x Single/Dual/Triple axis cross joysticks
Any combination of toggle switches, push-button controls, rotary
switches and key switches with removable key caps
Customized switches available upon request
Half duplex or Full duplex feedback
Frequency Range
4xxMHz or 8xxMhz or 9xxMHz or 1.216GHz or 2.4GHz**
Power (RF Output)
Typically ≤ 10mW E.I.R.P
Typical Operating Range
150m (492ft) for ≤ 1GHz 10mW module (Line-of-Sight)
70m (150ft) for 2.4GHz 10mW module
Safety
20-bit programmable address concept with up to 1,000,000
combinations
Operating Temperature Range
Active & Passive Stop Function
Parity and Checksum
-25°C . . . 70°C (-13°F . . . 158°F)
Humidity Range
0 - 97% maximum non-condensing
Response Time
Less than 100 msec.
Accessories and options
32Mb TFT driver memory
Cushion and customer logo option
Optional Custom housing colour
Belly belt, neck belt, chest belt and shoulder bar
RS232/CAN Cable control
TFT
2.4’’ full colour 240x360 back-lit TFT
Technical Specification Transmitter Nova L 2.4
*varies by transmitter configuration
** for full Channel Lists refer to Frequency Bands Radio Modules Charts
*** higher power available subject to country legislation
Battery & Charger
You may power your Nova L 2.4 transmitter with a Hetronic rechargeable NiMH 3.6V Grey MINI battery inserted in the battery
compartment in the bottom side of the transmitter.
Follow the instructions below to ensure best performance of your transmitter and prolonged battery lifetime.
1. Confirm that your batteries are fully-charged. See “Recharging Your Batteries” section in the UCH 2 Charger section.
2. Slide the recharged battery into the battery compartment at the bottom of the transmitter as shown, and snap it into place.
Cable Back-up
Cable control on Nova L 2.4 transmitters is possible through a connector plug installed on the side of the transmitter. The battery may be
left inside the battery compartment as the coder will automatically detect the presence of the cable, thus disable all wireless activity, and
recharge the battery if this is left inside the battery compartment in the transmitter. Refer to Section 6.9 for more details.
Accessories and Spare Parts
The standard belts for the NOVA L 2.4 transmitter are the chest, neck and belly belt and these can be obtained with or without the cushion
and with or without the logo.
Refer to the online web shop for respective part numbers of any other parts that may need replacement:
https://shop.hetronic.com.mt/en/home
NOTE: Any maintenance work or replacement of parts must be carried out by an authorized dealer or service centre specified by Hetronic.