USER MANUAL | UCH 2 CHARGER
1
MINI UCH 2 Battery Charger
Recharging your Batteries
To charge the MINI battery, it must be removed from the transmitter by lifting it up and sliding it out of the battery compartment. Slide the
battery in the charging unit until it clips in place and the yellow ‘CHARGE” LED flashes for two seconds. The yellow LED will remain ON for
the whole charging process. When the battery is fully charged, the “READY” green LED lights up and the “CHARGE” yellow LED goes off.
NOTE: If the yellow LED continues to blink after 2 seconds of inserting the battery in the charger, then the battery is defective and must be
replaced.
A switch on the indicator panel initiates fast charging of the battery. When “Fast Charge” is in progress a red LED turns on together with
the yellow “CHARGE” LED. When fast charging is complete, the green “READY” LED lights up and the red LED switches off.
Charging the MINI Battery
Leave the battery in the charger until it is needed. The charger supplies a “trickle” charge but it will not over-charge the battery.
The charger power cable is supplied with different plugging options: EU plug, cigarette lighter plug, US plug, etc. Below is the list of the
variants available.
Charger plug variations
To Next Page
Loading...
