USER MANUAL | NOVA TRANSMITTERS
22
9. Installing the Radio Remote Control
The following instructions are recommended so as to set up a properly operating radio remote control system. The radio remote
control must be installed by qualified personnel only.
Install the receiving unit’s antenna in the line of sight of the transmitting unit, with no electromagnetic shielding, and if possible,
not on metal surfaces so as to improve the operating range.
Do not bypass the safety instructions outlined by the equipment’s manufacturer.
Do not install the receiver unit too high above the ground as the unit may receive local radio signals that could disturb
transceiving operations.
To prevent water infiltrations, install the receiving unit vertically, with any cable clamps and any other connections at the bottom.
In case of strong mechanical vibrations, rubber shock-absorbing buffers may be installed between the machine and the
receiver.
To Next Page
Loading...
